油电晕英语怎么说及英文翻译

Ⅰ 机械英语，求达人翻译，机器翻译的别来捣乱，谢谢

其它装置（根据特定需要而配套的辅助装置）
Other device(the auxiliary assembly depend on certain need)

7.1涂增粘剂装置
7.1 Tackifier coating device

涂增粘剂装置主要由涂胶机和干燥装置组成。
Tackifier coating divice is mainly make up of drying machine and coater.
7.2加热装置
7.2 Heating device

7.2.1预加热装置
7.2.1 preheating device

纸基、布基等表面多孔的基材容易吸湿，会降低复合强度，固在挤出复合之前，应将基材预热，烘除潮气，以提高复合强度。
The moisture absorption of porous surface of base material like paper-base and cloth-base will case the rection in combined strength,so we preheat and dry the base material before extruded composite to increase the combined strength.

7.2.2后加热装置
7.2.2 Postheating device

对复合后的复合材料进行再加热处理，可以适当增加粘合强度，消除复合过程中产生的应力，后加热装置通常采用电阻加热器。
The postheating of composite material will increase combined strength and relief composite stress,it's usualy carry out by resistive heater.

7.3电晕处理装置
7.3 Corona disposal device

电晕处理装置的工作原理是在高压下放电，产生电火花冲击基材表面，使表面打毛变粗糙，扩大接触面积，提高基材表面润湿张力，粘合剂或熔融薄膜易均匀渗透到基材表面，从而提高复合强度。
电晕处理除以上的物理作用外，还有化学作用。经电晕处理后，薄膜表面张力提高至38～40N/mm。

Corona disposal is the process using the spark proced by electrion to impact the surface of base material,this will roughen its surface,increase the contact area and the wetting tension,easily to even penetration,so it will increase the combined strength.

There's also chemical effect beside the physical effect,after the corona disposal process,the surface tension will increas to 38～40N/mm.

7.4紫外线照射装置
7.4 Ultraviolet irradiation device

某些塑料薄膜与聚乙烯薄膜复合时，采用紫外线处理，能显著提高复合材料的粘合强度，此法较简单，易操作，既能提高复合材料的粘合强度，又可省去涂增粘剂设备。

The ultraviolet irradiation will increase the band strenth when some plastic film combine with polyethylene film,and this process is easily to carry out.

Ⅱ 在线翻译：中文翻译成英文

China is the world's largest coal proction and consumption Country，and is also one of the few countries which regard coal as the main sources of energy ,the coal energy rates was very high among energy consumption structure rates in our country.Among them, most of the coal combustion for power generation and heating instry.For large coal-fired power station and boiler,Pulverized coal combustion is the main way of combustion.However, It's one of the most important factors which has restricted the sustainable development that the use of pulverized coal combustion efficiency is not high and the environmental pollution caused by burning of our country one of the most important factors.

Based on the coal combustion efficiency and low pollution comprehensive consideration," corona charged pulverized coal combustion mechanism and experiment research" is put forward.By means of high voltage electrostatic field on the solid particles and gas can proce electric charge effect,On one hand, the gas atoms or ions moving kinetic energy is very high,and when contact with the pulverized coal particles,it'll transferred part of energy to the coal particle surface, and lead to Particles in an unstable high-energy state , increased the particle surface activity; On the other hand, oxygen, carbon monoxide, corona methane gas ion, electron, has high energy, those make accelerate coal particle combustion reaction rate, rece combustion reaction temperature become possible. However, in the actual proction process of coal, coal is usually in a flow state. From theoretic analysis, the flow of pulverized coal combustion efficiency of pulverized coal is greater than under the static state, Therefore,the pulverized coal flow in charge of combustion enhancement is possible.

In this paper,on the basis of pulverized coal particles are charged successfully, through using of the original cyclone electrostatic charge system to build the pulverized coal flow injection charge combustion system. using a photographic record and analysis of its ignition and combustion state, using sampling thermal analysis method of burnout to exploring Charged pulverized coal flow combustion status.

Key words: corona discharge, the pulverized coal flow, combustion, thermal analysis

翻译了一会，还挺累，不说百分百准确，但是基本没什么大的语法错误，望采纳。