补充电路英语怎么说及英文翻译

Ⅰ 急需英文翻译（下面的补充）！论文要用，语法正确就行。

This paper mainly introces the traffic light system based on PLC control design. Choose strong control functions CPU224 PLC/complete hardware circuit design, the mole in Micro/WIN32 STEP7 - the ladder-diagram programming software programming language, in order to realize the system control functions. And by using simulation software simulation system of simulation diagram demo, described in detail. The simulation results prove the effectiveness of the system. PLC in traffic lights on adaptive control method, a good way to solve the traffic flow is balanced and unstable pose the question, this system has the high anti-jamming and stability.

Ⅱ 英语高手帮我翻译一下，关于电路的。

翻译质量可保证，不过太长了，加点分吧？
1 Introction
1.引言
THE USE of conventional, unsymmetrical amplifier circuits in biomedical engineering is very limited, because of their inadequacy in suppressing power-line interference.常规的不对称放大器电路在生物医学工程中的使用是有限的，因为它们在抑制电力线路的干扰上存在不足之处。 Because one of the patient electrodes is directly connected to the amplifier
signal ground and the other is a high impedance point, the interference
current flows only through the grounded electrode. 因为病人的电极中有一个直接连接到放大器信号接地，另一个是高阻抗点，所以干扰电流只流过被接地的电极。The grounded electrode impedance voltage drop is amplified and leads to circuit saturation or masking of the useful biopotential
signal. 该接地电极阻抗的电压降被放大，并导致电路饱和，或者对有用生物电位信号的掩蔽。
Many biosignal acquisition devices could benefit from the use of only two electrodes. 很多生物信号采集装置可以通过仅采用两个电极而得到好处。Electrocardiogram monitoring in intensive care wards, ambulatory monitors, defibrillators etc.
are among the most common examples. 在重症监护病房中的心电图监控、门诊监测器、除颤器等是最常见的例子。
The most widely used technique for biosignal amplification is based on an instrumentation amplifier first-stage design, because of its ability to suppress the common mode interference
(NEUMAN, 1998). 最广泛使用的生物信号放大技术是基于一种仪表放大器的一级设计，因为它能抑制共模干扰（Neuman，1998）In two－electrode instrumentation, the
amplifier inputs must have a differential impedance that is as high as possible to avoid signal attenuation. 在双电极仪器应用中，放大器的输入必须有尽可能高的差分阻抗，以避免信号衰减。On the other hand, the amplifier should have reasonably low common mode impedance, to create a path for the common mode interference
currents without significant voltage drop, keeping both inputs in their specified operating voltage range. 另一方面，放大器的共模阻抗应该合理地低，以便为共模干扰电流创造一个通路而不致有明显的电压降，从而将两个输入都保持在它们规定的工作电压范围内。
THAKOR and WEBSTER (1980) introced a bootstrapped input stage. However, it has an inctive common mode input impedance, resulting in a very poor common mode
input current range, especially for higher frequencies. Thakor和Webster（1980）引入了一个自举（bootstapped）输入级，产生了很差的输入共模电流范围（特别是在较高的频率下）
A circuit for a two-electrode, non-differential amplifier was developed (DOBREV, 2002), the performance of which isquasi-equivalent to the differential amplifier described by DOBREV and DASKALOV (2002). Dobrev于2002年开发了一种用于双电极、无差动放大器的电路，其性能准-等效于Dobrev和Daskalov（2002）所描述的差分放大器。
Because the body as signal
source is floating and, in addition, the modern biopotential amplifiers are isolated, it is possible to drive actively one of the electrodes to the circuit common potential and thus to
balance the flowing interference currents. 因为作为信号源的人体是浮动的，而且现代的生物电位放大器是隔离的，所以有可能主动地将电极中的一个激励到电路的公共电位，并因此来平衡流过的干扰电流。
Now, a very simple, low-cost circuit of a two-electrode nondifferential
amplifier is suggested, where the interference current balancing is achieved by one operational amplifier
(OA) and two parallel RC networks.现在人们提出了一种很简单而又廉价的双电极、无差动放大器的电路，其中，干扰电流的平衡是靠一个运算放大器（OA）和两个并联的RC（阻容）网络实现的。

Ⅲ 各位高手，“模拟电路”、“数字电路“用英语怎么说啊！

- -!

模拟电路：Analog circuit
数字电路：Digital circuit

通常我们说的模数转换也就是A/D，就是取的英文首字母……

Ⅳ 模拟电子电路用英语怎么说

这样说
Analog electronic circuit
Analog 模拟
electronic circuit 电子电路

Ⅳ 电路板的英文怎么说

电路板
[词典] [电工] circuit board; [计] circuit card;
[例句]焊接电路板需要的工人更少了。
Fewer workers are needed to solder circuit boards

Ⅵ 可追加，高分求英文翻译，电路图方面。

这个开关是受汽车的点火钥匙控制的。
关掉钥匙时，同时控制两组电瓶之间的开关相连断开。断开后，XX系统只会从新装的电瓶上取电工作，而不会消耗原车的电量。
当钥匙打开发动车辆时，控制开关接上，发动机又会对新装的电瓶充电。
以此，这样循环工作。
This switch is controlled by the car’s ignition key.
When the key is turned off, the control link between two sets of batteries will be cut off. After being cut off, the xx system shall only work with the power from the newly installed battery instead of the original car battery.
When the car is turned on by the key, the control link will be connected and the engine will recharge the newly installed battery. So, this operation works in cycle.

在新装电瓶与XX系统之间的电路增加一个可以定时断电的电路，作用是司机下班后可以定时关闭XX系统。司机停车熄火后，在我们设定的时间内，可以自动断开新装电瓶与XX系统之间的供电线路，从而保护电瓶不会被耗尽。
司机上班发动车辆时，又会自动把XX系统的电源接通。
A timer controller is added to the circuit between the newly installed battery and the xx system, this is for the driver to set an auto- timing shut-off for the xx system when he’s off ty. After the driver has parked the car and switched off the engine, ring the period preset by us, the power supply from the newly installed battery to the xx system will be cut off, and the power depletion of the battery will be avoided.
When the driver comes back on ty and starts the car, the power supply to the xx system will be reconnected automatically.

Ⅶ 求电路专业英语翻译

我是学电专业的.刚考完科技英语.翻译不妥的地方还请
见谅。你可以查一些电专业（自动化）方面的书。我们图书馆有。
这些设备提供了必要的特点：能通过保持直流电流与电压的关系呈正弦曲线来显著的提升了低功率方面的不足。

Ⅷ 请翻译电路英语，谢谢帮忙

电流引起的峰值（信号）是一种泛宽合声的极非正弦波。
或 电流引起的峰值（信号）是一种泛宽的极非正弦谐波

太专业了！希望能对你有所帮助！非专业人员翻这东西不太好翻！见谅！

Ⅸ 请教：有关电路的英语翻译，要专业的

1 ， cmos输入弱内部下拉
2 ，异步明确派遣，有源低

Ⅹ “电路”用英语怎么说

circuit
circuitry
electrocircuit